General information about the Site

This lapidary and jewelry design community forum is dedicated to the novice, more experienced, and expert lapidaries and jewelry designers.

Forum cabochon in the Spotlight

Bob ( bobby1 ) shared this unknown druzy

Forum Jewelry Design in the Spotlight

John shared this beautiful pair of amethyst cufflinks

Forum Jewelry Design in the Spotlight

Mick B shared this stunning opal shell carving

Intarsias / Composites / Bead Making in the Spotlight

Kent shared this really nice Imperial Jasper pendant

Lapidary Related and Forum Member Shop Links

Brian Ababurko Silversmithing Classes / Rock Rollers Club

Dons Lapidary Arts

Idaho Rock Shop

Rare Rocks and Gems

Coyote Rainbow


Rocky Treasures

Talking Rocks

Fine Gem Designs

Idaho Rockman

Fine Woodwork and Lapidary

Darkstar Jewelry

DLC Gems

Teton Art Gallery

Art Cut Gems

Woman With A Torch

Lapidary Buy and Sell (Facebook Group)

Lapidary (Facebook Group)

Lapidary Equipment Marketplace (Facebook Group)

Lapidary / Gemstone Community Forum
June 16, 2019, 01:15:23 am
Welcome, Guest. Please login or register.

Login with username, password and session length
  Home Help Search Login Register  

Homebuilt 18" slab saw

Pages: 1 ... 3 4 [5]  All   Go Down
Author Topic: Homebuilt 18" slab saw  (Read 2841 times)
« Reply #60 on: March 22, 2012, 06:56:12 pm »

you do deserve a cheer. Great job..  ! question , how do you have the sled set up -- the attachment to the dride shaft//??


Not sure what your asking but the sled rides on the 2   1" round bars and is driven by the rear motor on a threaded rod if that helps.  Holes are drilled through the sled frame to accommodate the 1" rods  The threaded rod slips through holes in the center of the sled and there is a threaded catch and release attached to the sled. When in use the release is spring loaded to hole tension on to the threaded rod to screw the sled in motion. There is a lever to separate the two halves of the release so the sled can be moved back and forth by hand when needed
 Report Spam   Report to moderator    Logged 

Thaks for the info ! I am trying to revamp a split nut and cant seem to get it correct and was hopeing to get some ideas, could you post a pic of the split nut assembly

Report Spam   Logged

Pages: 1 ... 3 4 [5]  All   Go Up
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum | Buy traffic for your forum/website

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy