Lapidary / Gemstone Community Forum
July 06, 2020, 08:31:04 pm
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

Homebuilt 18" slab saw

Pages: 1 2 3 [4] 5  All   Go Down
  Print  
Author Topic: Homebuilt 18" slab saw  (Read 2411 times)
joec.
Guest
« Reply #45 on: February 23, 2012, 05:02:14 pm »

OK Folks!!! Here it is, and it WORKS!!!  Ignore the belts, they are temps until I get a new link belt I can custom the sizes









First slice was a coconut from Idaho


Results from first slice.


Idaho Plume ready to slice


Plume slice after taking a slice off the end to get a clean slab on both sides. Just over 1/4 inch all the way around so it appears to be working


Thanks for enjoying my project with me and the kudos given my way. It actually was not a difficult build. All said and done just about $1200 complete. Thanks again for putting up with me. Now my posts will be in the finished cab section!!!!

Joe
Report Spam   Logged


Pages: 1 2 3 [4] 5  All   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy