Lapidary / Gemstone Community Forum
September 24, 2020, 12:25:52 pm
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

What material should I use to make a gasket for a small saw?

Pages: [1]   Go Down
  Print  
Author Topic: What material should I use to make a gasket for a small saw?  (Read 58 times)
Hansel
Newbie
*
Offline Offline

Posts: 16


View Profile
« on: May 25, 2020, 04:22:01 pm »

I have a Star Diamond saw, model 10-PF.  They are no longer in business.  I need to make a gasket that goes between the top plated and the tank that holds the lubricating oil.  It is a rectangular shaped gasket.

What type of  material should I used to make the gasket?   

I have tried both cork and bicycle inner tube material, but both of these materials fail after some use.

Thank you

Report Spam   Logged

Share on Facebook Share on Twitter

catmandewe
Moderator
Hero Member
*****
Offline Offline

Gender: Male
Posts: 1160



View Profile WWW
« Reply #1 on: September 15, 2020, 09:08:42 am »

I have a Star Diamond saw, model 10-PF.  They are no longer in business.  I need to make a gasket that goes between the top plated and the tank that holds the lubricating oil.  It is a rectangular shaped gasket.

What type of  material should I used to make the gasket?   

I have tried both cork and bicycle inner tube material, but both of these materials fail after some use.

Thank you



I like to use cork but it needs to be sealed if you want it to last. After you cut the gasket out then coat it with silicone on both sides, put a sheet of saran wrap  on both sides and put it in the saw to cure, finger tighten the top on but don't crank it down, let it cure for a day or two, then pull the saran wrap off and you should have a gasket that is good for a few years.

Tony
Report Spam   Logged





Get free shipping and/or discounts on products at Cabking by using the following link.
http://cabking.com/ref/IdahoRockShop/


Pages: [1]   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy