Lapidary / Gemstone Community Forum
August 08, 2020, 09:12:46 am
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

Least noisy/messy slab and trim saws?

Pages: [1]   Go Down
  Print  
Author Topic: Least noisy/messy slab and trim saws?  (Read 86 times)
bobby1
Hero Member
*****
Offline Offline

Gender: Male
Posts: 3595


View Profile
« on: April 24, 2016, 03:50:51 pm »

Most slab saws run somewhat noisy. Our classroom at a junior college has a 24", A 20" and an 18" saw in the same smaller room as the grinders, sanders and polishers. We have converted them all to using mineral oil for safety and health considerations especially in the same room as the other equipment. In my experience all saws to a degree leak oil. I have an older Lortone 12" and a newer Lortone 14" as well as a very old Highland Park 18" saw. The 12" leaks the most and the 18" leaks the least.
Our trim saws all run water as a coolant/lubricant which from an equipment standpoint is somewhat far from ideal but from a safety and cleanup standpoint it is better. We have 12 trim saws, 6" through 10" and when they are all running it is quite noisy. Fortunately they are in another (crowded) room along with a 12" Lortone and a 14" Lortone saws. We went to the local hardware and got 1" thick 4' X 8" sheets of insulating panels to absorb much of the noise.
Bob
Report Spam   Logged



Pages: [1]   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy