Lapidary / Gemstone Community Forum
April 12, 2024, 01:54:05 pm
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

Changing out grinding wheels on Highland Park 8TSC

Pages: [1]   Go Down
  Print  
Author Topic: Changing out grinding wheels on Highland Park 8TSC  (Read 727 times)
tkcaz
Sr. Member
****
Offline Offline

Gender: Male
Posts: 294



View Profile
« on: April 19, 2014, 03:52:45 pm »

I have an ancient HP E20 and it is indeed one long drive shaft.  To replace either the saw blade or a grinder wheel you have to slip the belt off the drive pulley, then remove the grinder area cowling and the top of all the bearing blocks.  Putting everything back is a little trickier because the wheels and saw blade must be re-aligned.  Actually doing this is not quite as bad as it sounds, but it is definately NOT a "Qwik-Change" setup.
Report Spam   Logged

Tim



Pages: [1]   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy