Lapidary / Gemstone Community Forum
July 13, 2020, 11:36:04 am
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

Lining Inside of Slab Saw

Pages: [1] 2  All   Go Down
  Print  
Author Topic: Lining Inside of Slab Saw  (Read 571 times)
PanaMark
Full Member
***
Offline Offline

Gender: Male
Posts: 153


View Profile WWW
« on: December 28, 2013, 01:17:45 pm »

I have been thinking along the same lines as you are, but I am looking to find some shallow plastic trays that fit quite tight and fully in the bottom. That way I can drain and most of the sludge will be in the trays (along with some oil). Then by carefully lifting out the trays I can remove most of the sludge and chips, etc.

I think you might need something with a raised edge/lip otherwise the sludge will pour off as you lift it.

Maybe others have found a good solution they can share.  ?????
Report Spam   Logged

- Mark

Trying to see the potential in every rock (and everybody).


Pages: [1] 2  All   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy