Lapidary / Gemstone Community Forum
July 11, 2025, 08:47:56 am
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
 
  Home Help Search Login Register  

Biggs Jasper Pendant

Pages: 1 [2]  All   Go Down
  Print  
Author Topic: Biggs Jasper Pendant  (Read 4184 times)
mirkaba
Hero Member
*****
Offline Offline

Gender: Male
Posts: 2303



View Profile
« Reply #15 on: January 29, 2009, 11:31:49 am »

Okay, I'll give it a try. I use a little torch and sometimes I think it would be way cool to have a little cutting torch about the same size.  ;D Woulda knocked those pins right off..........Bob
Report Spam   Logged

Bob

Gathering dust in Montana.
Taogem
Hero Member
*****
Offline Offline

Gender: Male
Posts: 12153



View Profile
« Reply #16 on: February 02, 2009, 12:49:21 pm »

all I did was place the back on the charcoal block with the bezel around the back plate. 
Jason

I made my backing by shaping then hammering a round wire flat.

Now I am going to give the soldering of the bezel tape to the outside of it today like you did.

I just hope it solders well so there are no gaps. I have read how sometimes you can keep adding solder sometimes to fill little voids up even after the first solder has cooled.

Any way..... just a rambling a bit before I head out to the store.
Report Spam   Logged


Pages: 1 [2]  All   Go Up
  Print  
 
Jump to:  

Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy